To show the current neighbor table in the kernel, type. To remove an assigned IP address from a network interface ( eth0), type. To temporarily assign IP Address to a specific network interface ( eth0), type. $ ip addr showġ: lo: mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1 The following command will show the IP address and other information about a network interface.

(Read our article “ What’s Difference Between ifconfig and ip Command” to learn more about it.) It is a replacement for ifconfig and many other networking commands.

Ip command is another useful command-line utility for displaying and manipulating routing, network devices, interfaces. Note: Although ifconfig is a great tool, it is now obsolete (deprecated), its replacement is the ip command which is explained below. To deactivate or shut down a network interface, type. To assign an IP address to an interface, use the following command. To list all interfaces which are currently available, whether up or down, use the -a flag. TX packets:15793 errors:0 dropped:0 overruns:0 carrier:0 RX packets:15793 errors:0 dropped:0 overruns:0 frame:0 TX packets:125995 errors:0 dropped:0 overruns:0 carrier:0 RX packets:169854 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 $ ifconfigĮnp1s0 Link encap:Ethernet HWaddr 28:d2:44:eb:bd:98 Here is an example to display the status of all active network interfaces.

TraceRouteOK 3.33 downloading